Your vehicle is equipped with four dedicated lifting points 1 located underneath the vehicle.

warning

For your safety, we recommend that you contact an approved dealer to change the wheels. Risk of damage to the vehicle and particularly to the electric traction battery in the event of incorrect positioning of the lifting equipment.

The lifting points are compatible with the use of a jack equipped with a flat plate and a diameter between 80 mm and 140 mm.

The jack used must comply with the country's current standards and regulations. The jack lifting capacity must be greater than the vehicle's maximum permissible weight on the relevant axle Vehicle identification plates.

The jack is only to be used to lift the vehicle in order to change the wheels. This must be performed:

  • with the parking brake applied,
  • with the vehicle unladen,
  • on level, non-slip and solid ground.

Before lifting the vehicle, the plate of the jack must be correctly positioned against the lifting point 1.

warning

To prevent any risk of injury or damage to the vehicle, the jack must only be cranked until the wheel you are replacing is at most three centimetres off the ground.

Risk of injury. Risk of damage to the vehicle.

warning

For safety reasons, the vehicle lifting points must only be used to change the wheels. Under no circumstances should they be used:

  • to carry out a repair;
  • to access the underside of the vehicle.

Risk of injury. Risk of damage to the vehicle.